Rose-electronics MultiVideo Manuel d'utilisateur télécharger pdf (Page 46)

ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL

If any of these errors occur, check the RS232 cable, the connectors, and

the adapter. Make sure they are in good working order. Verify the

communication program is configured correctly. Enter “Y” to try upgrading

the flash again. If programming is unsuccessful, the unit should be

serviced.

Method 2 – Using the front panel switches with a file copy.

1. Press both the - and + switches on the front panel and power up the

UltraView Pro. The UltraView Pro is ready to accept the upgrade file.

LED 1 will light indicating the unit is set at 9600 baud. To use 57600

baud, press the + switch, LED 4 will light. Copy the file to the unit.

While the file is being copied LED 1 or 4 will flash. Once the file is

copied, LED 2 will light.

2. Press and release the + switch, LED 2 flashes off for a brief instant.

The flash is now being programmed and verified. LED 3 now lights.

3. Press and release the + switch, LED 3 flashes off for a brief instant.

The new firmware is now run and diagnostic information is sent to the

on-screen display. Observe the new revision number matches that of

the file. LED 4 now lights.

4. Press and release the + switch. LED 1 now lights. The box is now

operational and port 1 is selected or the login box is waiting for its

password. The flash loading procedure is complete.

Figure 16. Power-on diagnostic screen

Welcome to UltraView Pro

Power on diagnostics

Kernel revision - - - - - - P3

Hardware type - - - - - - PC

Kernel checksum - - - - GOOD

Static ram - - - - - - - - - GOOD

Com interface - - - - - - GOOD

Program revision - - - - UP18

Program checksum - - GOOD

Total ports found - - - - 08

Config checksum - - - - GOOD

PC keyboard detected

PS/2 mouse detected

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 59 60

Pas de commentaire

Rose-electronics MultiVideo Manuel d'utilisateur Page 46