Rose electronics CrystalView Plus Manuel d'instructions télécharger pdf (Page 37)

CRYSTALVIEW PLUS USB INSTALLATION AND OPERATIONS MANUAL

Appendix E. Quick Installation/Setup Guide

This appendix provides a quick installation and video compensation guide

for experienced users. Refer to the complete installation guide for a more

detailed set of instructions.

Install units

1. Connect Remote unit to KVM, serial & audio devices, additional

video monitors and power

2. Connect Local unit to Computer or KVM switch

3. Connect Local unit to Remote unit with CAT5, CAT5e, or CAT6

cable

4. Apply power to all equipment

Select video channel to adjust

5. Enter Command Mode then select Channel 1, 2, 0 (all)

Display Video test card

6. http://www.rose.com/htm/crvtestcard.htm

Reset selected channel

7. <left Control> + <Home>

Apply Assisted EQ

8. <Left Control> + <Page Up> (Next)

<Left Control> + <Page Down> (Previous)

Adjust Skew

9. Adjust individual color delays until test card’s RED/GREEN/BLUE

vertical lines are aligned.

Fine tune LF and EQ values

10. <See Table 1 for commands>

Exit Command mode and save

11. <ESC>

1 2 ... 32 33 34 35 36 37 38 39 40

Pas de commentaire

Rose electronics CrystalView Plus Manuel d'instructions Page 37