Rose electronics 4x Manuel d'instructions télécharger pdf (Page 16)

INSTALLATION

ULTRAMATRIX “UMX” SERIES INSTALLATION AND OPERATIONS MANUAL

Switch installation – Single unit

The basic installation of a single UltraMatrix switch is an easy and straightforward procedure. To install a single

switch, perform the below steps for all computers/servers that will be connected. It is recommended that all

computers and servers be powered off. When a computer is connected and then booted, the UltraMatrix will

automatically determine the keyboard and mouse types used for that computer and no pre-configuration of the CPU

port is needed. If removing power from a computer or server is not practical, pre-configure the UltraMatrix’s CPU

port to define that CPU port’s keyboard and mouse types. The default keyboard type is PC mode 2 and the mouse

type is PS/2. If the computer being connected uses a PC2 keyboard and PS/2 mouse, no pre-configuration of the

CPU port is needed. If not, pre-configure the CPU port (Steps 5a-f) for the keyboard and mouse types for that CPU

before connecting the computer. This procedure should only be done if the CPUs keyboard and mouse can be

disconnected and re-connected with power applied to the computer without affecting the interface.

Figure 4. Installation - Single unit

PLEASE REFER TO THE SAFETY SECTION

BEFORE INSTALLATION

CPU’s 1-16

KVM’s 1-4

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Pas de commentaire

Rose electronics 4x Manuel d'instructions Page 16