Rose electronics switch/hub Manuel d'instructions télécharger pdf (Page 19)

ORION LC Installation and Operations Manual

Crosspoint-Switch Installation – 5 x 3

The 5 x 3 configuration allows you to connect five computers to the Orion

LC and display the video on up to 3 DVI monitors.

To configure Orion LC for a 5 input, 3 output Crosspoint switch, set the dip

switches and CATx or fiber cabling as shown below.

The 5 x 3 configuration allows

you to connect 5 computers to

the Orion LC and display the

video (+audio option) on up to 3

DVI monitors.

To configure Orion LC for a 5

input, 3 output Cross-Point

Switch, set the dip switch 1and 5

ON and 2, 3, and 4 OFF and

connect the CATx or fiber

cabling as shown.

Connect a DVI MM video cable from

the CPU’s DVI graphic cards to the

DVI-In ports on the transmitters.

Connect 5 CATx or fiber cables from

the transmitters to the five Orion LC

port labeled “T”.

Connect up to 3 CATx or fiber

cables from the Orion LC ports

labeled “R” to the receivers.

Connect a DVI monitor to each

receiver’s DVI output.

Figure 9. Cross Point Switch - 5 x 3

The 5 x 3 configuration allows you to route the video from any of the 5

computers to any connected monitor. In the above example, computer #1’s

video is displayed on 1 monitor, computer #2’s video is displayed on 1

monitor, computer #3’s video is displayed on 1 monitor, and computer #4

and #5 are not connected to a monitor. Issuing serial commands can route

any selected computer to any of the connected monitors.

The serial switching commands for this configuration is:

0x02, 0x47, 0x81, 0x81, 0x03 (Switch output 1 to input 1)

0x02, 0x47, 0x82, 0x82, 0x03 (Switch output 2 to input 2)

0x02, 0x47, 0x83, 0x83, 0x03 (Switch output 3 to input 3)

(Input 4 and 5 are not displayed)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Pas de commentaire

Rose electronics switch/hub Manuel d'instructions Page 19