Rose electronics Translator Manuel d'instructions télécharger pdf (Page 14)

INSTALLATION

SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL

Organizing the system

It is recommended that before any ServeView Pro configuration or cable

connections be made, plan how the system will be laid out, the placement

of the CPUs and the placement of the ServeView Pro. Take into

consideration the cable lengths needed to connect to the KVM station and

each CPU. Identify which computer will be connected to each CPU

connector and if that computer uses a PC mode 2 keyboard and PS/2

mouse. If not, the CPU port should be pre-configured to change the default

keyboard and mouse types to the correct settings.

If you are adding Slave units to expand your system, it is important that you

understand the width command, especially if your system consists of

different models (4-CPU ports, 8-CPU ports, and 16-CPU ports). For

example, if your system consists of an 8-port master, two 8-port Slave units

and one 4-port Slave unit, and you program the expansion width to 8, there

will be 4 blind ports on the 4-port unit. In other words, the 4-port unit will

appear to the system as having 8 CPU ports. CPU ports 5-8 are blind ports.

If you program the expansion width to 4, then only CPU ports 1-4 on the 8-

port Slave units can be accessed. In systems that have a mixture of

models, it is recommended that the width value be set to the number of

CPU ports on the Slave unit with the most CPU ports.

Installation – Single unit

This section explains how to connect and initially configure the ServeView

Pro. If you are cascading two or more ServeView Pro units together, please

refer to the Cascade installation section.

Connecting the KVM station

Connect the KVM station’s keyboard, video monitor, and mouse cables to

the corresponding connectors on a KVM cable as shown in Figure 3. The

KVM cable should have the correct connector types for the equipment

used. Connect the DB25M connector into the connector labeled

“Monitor/Keyboard/Mouse” on the ServeView Pro “M” chassis rear panel or

the KVM-1 connector on the “B” and “C” chassis. If a serial mouse is used

on a KVM station, all mice in the system (on every computer) must be a

serial mouse.

Apply power

For the “M” chassis, connect the power transformer to a 110/220-volt

source and to the DIN 5F power adapter connector on the rear panel. Press

the ON/OFF button in the front panel once to turn on the unit.

For the “B” and “C” chassis, connect a power cord to 110-220-volt source

and to the IEC320 connector on the rear panel. Press the rocker switch to

the ON position.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Pas de commentaire

Rose electronics Translator Manuel d'instructions Page 14