Rose electronics Translator Manuel d'instructions télécharger pdf (Page 20)

OPERATION

SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL

Selecting a computer

To connect to a computer, you can select it from the ServeView Pro’s front

panel, select it by keyboard commands, or select it through the RS232

serial port.

Selecting a computer from the front panel

Using the - and + buttons on the front panel will switch to the previous (-)

computer port or advance (+) to the next computer.

Selecting a computer using keyboard commands

Press and release the left control <Ctrl> key, then enter the computer port

number. Pressing and releasing the left control <Ctrl> key then the + or -

key will advance forward or backwards one sequential port.

Selecting a computer through the RS232 port

Selecting a computer can be done through the RS232 port if needed.

Contact Rose Electronics Technical support for details.

Reset to factory defaults

To reset the ServeView Pro to the original factory default settings, first,

power down the unit, press and hold the – (minus) switch in and turn the

unit’s power on. Keep the – (minus) switch held in until the unit switches to

the last port on the unit (port 4, 8, or 16). If you release the – (minus)

switch before the last port is switched to, the defaults will not be restored.

Rack mounting

The ServeView Pro can be rack mounted using a Rose Electronics

Rackmount kit. See Appendix D and E for instructions and Appendix B for

part numbers.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Pas de commentaire

Rose electronics Translator Manuel d'instructions Page 20