Rose electronics Translator Manuel d'instructions télécharger pdf (Page 21)

SERIAL PORT

SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL

Serial Port (RS232)

The RS232 serial port on the ServeView Pro’s rear panel is used for

sending switching commands from a stand-alone computer or terminal or to

load flash firmware upgrades to the unit. A serial cable and an RJ to DB9

adapter are included with the unit. Perform steps 1-3 below to use the serial

port.

1. Connect the serial cable to the RS232 serial port on the rear panel of the

ServeView Pro and to the RJ12 connector on the adapter.

2. Connect the DB9 connector on the adapter to the stand-alone computer

or terminals DB9 COM port.

3. Set the computers communication program for:

a. 9600 baud

b. no parity

c. 8 bits

d. 1 stop-bit

Firmware update

The ServeView Pro’s flash memory can be updated with the latest firmware

using the RS232 serial port. Updates can be obtained from Rose

Electronics web site at www.rose.com. Verify the unit’s program and kernel

versions against the current versions on our web site. To verify the

program version, start a text editor application like notepad, press and

release the left control (Ctrl) key, then press the “I” key and the program

version will display.

The latest firmware file names on Rose Electronics web site are:

UPPxx.hex – main program and UPKxx.hex – kernel program.

(xx = the revision number)

To update the ServeView Pro’s firmware, first download the latest revision

from Rose Electronics web site and save it to a stand-alone computer that

is not connected to the ServeView Pro. Connect the serial cable from the

ServeView Pro to the serial port of the stand-alone computer as described

in steps 1-3. There are two methods of loading the downloaded programs

to flash memory.

Method 1 – Using a communication program

1. Press both the - and + switches on the front panel and power on the

ServeView Pro. LED 1 will light indicating the unit is ready to accept

the upgrade file at 9600 baud. To use 57600 baud rate, press the +

switch and LED 1 will turn off and LED 4 will light.

2. Run your communication program. Set the baud rate to the correct

rate and put the program in direct connect mode. When the - or +

switch is pressed, you should see the message:

”Waiting for file at 9600 or 57600 baud.”

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Rose electronics Translator Manuel d'instructions Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs KVM Rose electronics Translator